How do I fix code P0745?

What Repairs Will Fix P0745?

1. Changing the fluid and filter.
2. Replace faulty pressure control solenoid.
3. Repair or replace a faulty transmission pump.
4. Repair or replace defective transmission valve body.
5. Transmission flush to clean passages.
6. Cleaning corrosion from connectors.
7. Repairing or replacing wiring.

What does P0745 mean?

When the code P0745 appears in your powertrain control module (PCM), it means that the PCM is not reading the correct electrical voltage drops from the Pressure Control Solenoid as it does its job.

What is pressure control solenoid A?

Pressure control solenoids are spring-loaded devices that the engine/transmission control modules use to direct the flow of pressurized transmission fluid to change gears. If the computer is unable to properly control pressure control solenoid ‘A’, then it will store a P0746 diagnostic trouble code.

What is the code P0778?

P0778 is a diagnostic trouble code (DTC) for “Pressure Control Solenoid B Electrical”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

What does P0776 mean?

Code P0776 is an indication that your vehicle’s PCM has found an abnormality related to the electronic pressure control solenoid circuit or simply the solenoid itself.

What does the OBDII code p0745 mean for Nissan?

P0745 NISSAN Line Pressure Solenoid Valve Fault. AutoCodes – OBDII Code List – P0745 NISSAN.

What does the p0745 code mean on a Ford F150?

The code P0745 is set by the PCM when the Pressure Control Solenoid “A” is experiencing a general malfunction.

What does the p0745 code on the TCM code mean?

The P0745 is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve. The Pressure Control (PC) Solenoid Valve an electronic pressure regulator that controls transmission line pressure based on current flow through its coil windings.

What causes error code p0745 on a Toyota Tiida?

P0745 can be due to the Faulty dropping resistor (12ohms). A friend sent his Tiida to a mechanic who changed the Auto Trans Fluid (7.9L) and then the solenoid but fault still existed. Eventually he checked the dropping resistor and found to be faulty.