What does red light on grinder pump mean?
Your grinder pump station will provide a visual flashing red light alarm anytime the level of storage tank is higher than normal level. If you find your pump station with this condition stop water use immediately and call your homebuilder as soon as possible.
Why is my grinder pump light on?
If there is too much flow going into your grinder pump unit, the high sewage level will automatically trigger an alarm horn and light to alert you of the problem. In many instances, the problem could be an excessive amount of flow to the grinder pump.
How long does a sewage grinder pump last?
You can expect a sewage grinder pump to last 6 to 16 years, with an average of 9 years. A grinder pump is installed along the drain line to a municipal sewer system or private septic tank when the pipe slope is not enough to flow by gravity.
What causes a grinder pump to fail?
Blockage: Grease and dirt can build up in the grinder pump, and create blockage. If you notice slow drains or a large number of clogs—or sewage backs up into your home—then call immediately for professional plumbers. Clots: A large enough item becoming stuck inside the pump will then allow smaller items to build up.
How long should a grinder pump run?
A grinder pump will normally run for one or two minutes and automatically turn off when the wastewater in the tank reaches the preset off level. The pump is powered by electricity and is connected to a control panel typically mounted on the side of your house or near the tank.
What can clog a grinder pump?
Problems You May Encounter with Your Home’s Grinder Pump
- Frozen pump: Your grinder pump is buried down in the ground at a level below the frost line to prevent it from freezing during our chilly winters.
- Blockage: Grease and dirt can build up in the grinder pump, and create blockage.
Can a grinder pump get clogged?
You can also have blockage problems due to careless dumping of waste into your pipes, such as oil, paint, kitty litter and any other insoluble items. You will have these items building up at the bottom of your tank before they clump together with debris and jamb the sump pump.
How do I know if my grinder pump is working?
If your grinder pump is working properly, you shouldn’t notice it at all — the pump will turn on as needed and pump down the tank; its noise level is similar to that of a washing machine. The pump will turn off after a few minutes.
How do you test a grinder pump?
To do this, run an inside faucet for about 10 minutes or 30 gallons, just long enough for the grinder pump to begin working. To verify that the pump is running, it may be necessary to go outside near the pump and listen for it to start. After the pump starts, turn the faucet off.
What are the common problems with a grinder pump?
3 Common Grinder Pump Problems 1 Blocking Grinder pumps can easily be blocked by dirt and debris. 2 Clotting If larger pieces of debris can get stuck in the pump itself, then smaller items can also cause a gradual build-up of silt which also damages the pump. 3 Freezing
What should I do if my grinder is not working?
Check that the outlet that is powering the grinder pump is getting power. If you can, try unplugging the grinder pump from the outlet and plug in a light or another electrical device to test that there is power.
How does a toilet paper grinder pump work?
At the bottom of the grinder pump is an impellor that will spin, which sucks in the wastewater and anything else that has made its way into the holding tank, such as toilet paper and human waste. The grinder pump will run for a few minutes, while the cutting blades grind the waste into tiny particles in the same way that garbage disposals do.
How does a garbage disposal grinder pump work?
The grinder pump will run for a few minutes, while the cutting blades grind the waste into tiny particles in the same way that garbage disposals do. The pump then forces the wastewater out of the tank and into a pressurized city sewer main.
https://www.youtube.com/watch?v=gukhXfkRQok