How do you use an oxygen concentrator for Lampworking?

Starts here4:54Oxygen Concentrator | Lampworking | Homefill | Fusing Shop – YouTubeYouTubeStart of suggested clipEnd of suggested clip59 second suggested clipAnd then it goes into the tank. And i have it split on this like little t. Here. So and then it goesMoreAnd then it goes into the tank. And i have it split on this like little t. Here. So and then it goes to my regulator. And to my um flashback resistor and then to my torches. So that is the setup.

How effective are oxygen generators?

The oxygen concentrator is an effective supply source in home oxygen-therapy (HO). Only 13 concentrators (41.9%) supplied a percentage of oxygen higher than 87% at a flow of two liters per minute.

What is an oxygen generator used for?

Oxygen generators separate oxygen from air so that the gas can be fed into industrial processes in real-time or stored in pressure tanks. Oxygen generators are used in dozens of industrial applications ranging from gold mining to aquaculture to life support.

Are oxygen concentrators illegal?

The FDA requires a prescription for the sale of oxygen concentrators. Since it is technically illegal to sell oxygen machines over auction sites (without a prescription), a consumer’s remedy should something go wrong is minimal.

How do you set up an oxygen concentrator for blowing glass?

Oxygen Concentrators and Glass Blowing/Beadmaking

  1. Open Oxygen Valve on torch.
  2. Close Fuel Valve on torch.
  3. Turn on Oxygen Concentrator, set to maximum LPM.
  4. Let the concentrator run 15 minutes to achieve maximum purity.
  5. Turn off Oxygen Valve on torch.
  6. Open Fuel Valve on torch, and light.

How do you hook up a oxygen concentrator to a torch?

Starts here0:00Oxygen Concentrator set up with Torches vs tanks – YouTubeYouTube

What is the difference between an oxygen generator and an oxygen concentrator?

An oxygen concentrator is a tiny medical oxygen equipment designed for home usage. On the other hand, an oxygen generator usually refers to larger systems or systems intended for industrial use.

What can you make Lampworking?

Lampworking is used to create artwork, including beads, figurines, marbles, small vessels, Christmas tree ornaments, and much more. It is also used to create scientific instruments as well as glass models of animal and botanical subjects.

How do you make a Lampworking torch?

Starts here8:01Setting Up a 2-Inlet Torch for Glass Blowing (How to) – YouTubeYouTube

What kind of oxygen do you use to light a lamp?

As we all know, lampworkers add a flow of oxygen to a flame to get higher temperatures and a more defined shape. Most lampworkers use tanked propane and tanked oxy, both under high pressure, with appropriate regulators. Tanked oxygen in particular is (imho) a rather unnerving roommate.

What is the logic controller on a portable oxygen generator?

Our proprietary logic controller senses stored oxygen pressure and turns the compressor and the attached oxygen concentrators on and off to keep up with demand. Your usage determines how often the system runs to generate oxygen.

How does a nitrogen oxygen generator work?

When the chamber decompresses, the nitrogen is released and vented from a separate exhaust. The two chambers operate on a regular cycle like a two-cylinder engine; when one is “inhaling” the other is “exhaling” to provide a fairly even flow of nearly-pure oxygen to the output.

How much pure oxygen is in a 5lpm generator?

Another important specification is purity. Most units can’t put out 90 percent pure oxygen at their highest flow; typical numbers might be 85 percent at 5lpm, 90 percent at 4.5lpm, and 95 percent at 4lpm for a unit rated 5lpm.