How do I clear the Dell server event log?

2. Viewing System Event Log using System Setup

  1. Press F2 during POST to enter System Setup.
  2. Selected iDRAC Settings.
  3. Go to System Event Log.
  4. To clear the records, select Yes. Else, select No.
  5. To view the system events, click Display System Event Log.
  6. Click Back, click Finish, and then click Yes.

How do I check Dell server logs?

Follow these steps to view, export and clear the SEL, in iDRAC Web interface:

  1. Enter the iDRAC web interface.
  2. Go to Overview > Server > Logs.
  3. The first page shown is the Server Event Log (SEL)
  4. Click Save As on the bottom of the list to save the SEL to a location of your choice.

How do I clear iDRAC errors?

Simply use the down arrow key to navigate all the way to the bottom of the list where it says to the IDRAC setting. Hit enter. Select yes to clear and exit the menu and it will prompt you once you confirm exiting to save changes. Once it’s cleared, hit escape until you exit the Remote Access screen.

How do I clear idrac9 logs?

Clearing System Event Log via iDrac

  1. Click Overview > Server > Logs in the left pane.
  2. Click Logs on the taskbar at the top of the screen.
  3. Click the Clear Log button.

How do you clear the ESM log on a Dell Poweredge server?

ESM Log size is full – How to clear

  1. Open Dell Manage console, go to logs tab.
  2. Then select ESM logs, you will see an export option.
  3. Export the logs and save it on local drive for future use.
  4. Now open command prompt and Runas administrator.
  5. Type omconfig system esmlog action=clear.
  6. Done, your logs are cleared.

How do I clear UCS SEL logs?

After Cisco UCS Manager GUI displays the system event log in the SEL Logs tab, click Clear. This action triggers an automatic backup if Clear is enabled in the SEL policy Action option box.

What is Dell TSR?

Technical Support Report (TSR)

How do I get Dell CMC logs?

It is recommended to use PuTTY to connect to the controller and gather logs.

  1. Download PuTTy.
  2. Open PuTTY and enable logging (Figure 1)
  3. Under Session, specify the CMC hostname or CMC IP address and click open (Figure 1)
  4. Type the Command that you want to run.
  5. To end the session type the command: exit.

How do you delete iDRAC logs?

In the iDRAC web console, click Overview > Server > Logs Page . Click Clear Log.

What is Dell ESM?

There are two available hardware logs, depending on your system: the Embedded System Management (ESM) log and the System Event Log (SEL). The ESM log and SEL are each a set of embedded instructions that can send hardware status messages to systems management software.

Categories: Articles