What is Brickmould on a window?

Brickmould is an exterior trim which frames the window like a picture frame. Functionally, it is used to fill the gap between the window and the exterior surface (stone, siding, etc.); aesthetically, it lends the home a richer look.

How do you install a window without nail flange?

How to Install a Window Without Nailing Fins

1. Measure the dimensions of the window with a tape measure and frame the rough opening to be 1/2 inch wider and 1/2 inch longer.
2. Seal the sill with tarpaper or with a vinyl sill sealer.
3. Close the window you are going to install.

Where do you nail brick molding?

Position the side pieces first, pressing them out to the edge of the brick. Nail through the inside edge of the molding with 2-inch nails from a pneumatic finish nailer, one every 8 inches. Do this on both sides.

Is brick molding waterproof?

Apart from windows, brickmold can serve as a casing around the door frames at the exterior part of the building. It also serves as a beautiful boundary between the framing and siding. It also acts as a weatherproof for doors.

What is a nail fin on a window?

What are nailing fins? Nailing fins, sometimes called mounting flanges, are the thin strips installed on the exterior sides of a window. Unlike a “front flange” which is a decorative trim piece, a nailing fin is usually set back from the outer edge of the window frame and has fastener holes punched into it.

How do you repair a brick mold?

To replace damaged brick mold door casing:

1. Use a sharp utility knife to cut through the caulking holding the brick mold.
2. Pry off the damaged brick mold using a flat pry bar.
3. Miter a piece of solid vinyl door casing, and cut it to length.
4. Predrill the holes in the vinyl brick mold, and nail it in place.

How do you install brick molding around a window?

You need 12.5 feet of brick molding. Cut your length of brick molding down to the correct lengths, taking care to make the corner cuts at a 45 degree angle. Attach the brick molding around the window using the nails and hammer. Stagger the nails at 2 foot intervals around the window. Apply a small bead of caulk and distribute it smoothly.

How do you attach trim clips to brickmould?

Trim Clip Attachment 8 Install Trim Clips onto Window Frame. 1.5” Space Trim Clip 1.5” away from Corner. Tap two Trim Clips into each corner. If length of window side is 47″ or longer, tap additional trim clip midway between two corner clips. 10 If installing Brickmould with Sill Nose, do not place Trim Clips on Window Sill.

What is a brick mould used for on a door?

VERSATEX brick mould is used to trim an exterior door or window frame. It provides a stop for the brick, siding, or other exterior facing materials which butt up against it. It also forms a rabbet with the frame for the combination, screen, or storm door.

How do you attach brick molding to a door jamb?

Starting at the center of the head casing, nail the brick molding into place. Use four #3 or #4 finishing nails along the inside edge to attach the head casing to the door jamb. Use three or four #6 finishing nails along the outside edge to attach the head casing to the door jamb.